From ImageStream Router Documentation
Revision as of 16:19, 25 April 2008 by Syoder
- Sets the intended bandwidth in bits per second. This command only affects the output of the "stats" program and does not set internal clock speeds. See baud to set internal clocking for interfaces.
NOTE: When used in conjunction with ATM QoS commands this value is used to calculate the correct ATM QoS settings. When this command is used on a Frame-relay interface this is used to setup rate-limiting on the interface.
- bits_per_second - Non-negative integer which represents how much data an interface can push.
- bandwidth 2000000 - Sets the interface to 2 Mbps
- bandwidth 100000000 - Sets the interface to 100Mbps